210 South French Ave. , Sanford , Florida 32771 (407)-330-2056
....Biltwell Exhaust Kit....
210 South French Ave. ,
Sanford , Florida 32771
(407)-330-2056
....Biltwell
Exhaust Kit....
|
BILTWELL
CUSTOM EXHAUST KIT
If the “theme” for your next bike includes handcrafting an original custom exhaust system for less than $200, our Builder Exhaust Kit will get you started. WHAT’S HERE: Our Builder Exhaust Kit is exactly what its name implies: a selection of pre-fabbed tubing, header flanges and exhaust tips that puts the art of custom exhaust building in the hands of backyard fabricators. Each Builder Exhaust Kit includes the following: Two 16-inch-long (350mm) straight sections Two 3.5-inch radius (90mm) U-bends with straights Two 5-inch radius 134mm) U-bends with straights Two Evolution cylinder flanges Two Shovelhead cylinder flanges Two Ironhead cylinder flanges Two fishtail tips In other words, everything you need to build a set of pipes for one bike, with enough scraps left over to start on two more. If you’re clever—and assuming your stable of projects includes the right combination of Harley motors—you could build three sets of pipes for less than 300 dollars. All it would take is a visit to the local muffler shop for a couple more feet of 1-3/4-inch steel tubing. WHAT’S MISSING: This kit doesn’t include mounting tabs. You can fabricate these out of flat stock, or buy some at any good industrial hardware store. Snap rings and exhaust flange collars for Evo’s and Shovelheads are not included. You can pick these up at any swap meet or local shop. SURFACE FINISH: All raw tube sections are pre-polished to make chroming after joint finishing easier. Of course, the welded joints will require polishing if you expect a show-quality appearance, but most Biltwell customers simply paint their pipes or wrap them with hot-rod header tape. 
|
|
